Journal of Thermal Analysis and Calorimetry
Volume/Issue:
Volume 106: Issue 1
The rigid amorphous fraction in semicrystalline macromolecules
Author:
Joseph D. Menczel Alcon Laboratories (retired), 412 Stampede Court, Fort Worth, TX, 76123, USA

Search for other papers by Joseph D. Menczel in
Current site
Google Scholar
PubMed Close
Pages:
7–24
Online Publication Date:
01 May 2011
Publication Date:
01 Oct 2011
Article Category:
Research Article
DOI:
https://doi.org/10.1007/s10973-011-1496-7
Keywords:
DSC; Semicrystalline polymers; Rigid amorphous fraction; Temperature calibration of DSC’s on cooling; Enthalpy relaxation; Time dependence of the glass transition
Restricted access

Abstract

The first experimental evidence of the existence of the rigid amorphous fraction (RAF) was reported by Menczel and Wunderlich for several semicrystalline polymers. It was observed that the hysteresis peak at the glass transition was absent when these polymers were heated much faster than they had previously been cooled. In the glass transition behavior of poly(ethylene terephthalate) (PET), the hysteresis peak gradually disappeared as the crystallinity increased. At the same time, it was noted that the ΔCp of higher crystallinity PET samples was much smaller than could be expected on the basis of the crystallinity calculated from the heat of fusion. It was also observed that this behavior was not unique to PET only, but is characteristic of most semicrystalline polymers: the sum of the crystallinity calculated from the heat of fusion and the amorphous content calculated from the ΔCp at the glass transition is much less than 100% (a typical difference is ~20–30%). This 20–30% difference was attributed to the existence of the “RAF”. The presence of the RAF also affected the unfreezing behavior of the “mobile (or traditional) amorphous fraction.” As a consequence, the phenomenon of the enthalpy relaxation diminished with increasing rigid amorphous content. It was suggested that the disappearance of the enthalpy relaxation was caused by the disappearance or drastic decrease of the time dependence of the glass transition. To check the validity of this suggestion, the glass transition had to be also measured on cooling in order to overlay it on the DSC curves measured on heating. However, before this overlaying work could be accomplished, the exact temperatures on cooling had to be determined since the temperature of the DSC instruments that time could not be calibrated on cooling using the usual low molecular weight standards due to the common phenomenon of supercooling. Therefore, a temperature calibration method needed to be developed for cooling DSC experiments utilizing high purity liquid crystals using the isotropic → nematic, the isotropic → cholesteric, and other liquid crystal → liquid crystal transitions. After the cooling calibration was accomplished, the cooling glass transition experiments indicated that the glass transition in semicrystalline polymers is not completely time independent, because its width depends on the ramp rate. However, it was shown that the time dependence is drastically reduced, and the midpoint of the glass transition seems to be constant which can explain the absence of the enthalpy relaxation. The work presented here has led to a number of studies showing the universality of the rigid amorphous phase for semicrystalline polymers as well as an ASTM standard for DSC cooling calibration.

  • Collapse
  • Expand
Cover Journal of Thermal Analysis and Calorimetry
Journal of Thermal Analysis and Calorimetry
Print ISSN:
1388-6150
Online ISSN:
1572-8943

To see the editorial board, please visit the website of Springer Nature.

Manuscript Submission: HERE

For subscription options, please visit the website of Springer Nature.

Journal of Thermal Analysis and Calorimetry
Language English
Size A4
Year of
Foundation		 1969
Volumes
per Year		 1
Issues
per Year		 24
Founder Akadémiai Kiadó
Founder's
Address		 H-1117 Budapest, Hungary 1516 Budapest, PO Box 245.
Publisher Akadémiai Kiadó
Springer Nature Switzerland AG
Publisher's
Address		 H-1117 Budapest, Hungary 1516 Budapest, PO Box 245.
CH-6330 Cham, Switzerland Gewerbestrasse 11.
Responsible
Publisher		 Chief Executive Officer, Akadémiai Kiadó
ISSN 1388-6150 (Print)
ISSN 1588-2926 (Online)

Monthly Content Usage

Abstract Views Full Text Views PDF Downloads
Apr 2024 22 0 0
May 2024 10 0 0
Jun 2024 7 1 1
Jul 2024 14 0 0
Aug 2024 35 0 0
Sep 2024 47 1 1
Oct 2024 61 0 0