The design of inductors is not an easy and cheap task considering the dimensions, the nominal value of inductance, the quality factor and the impedance of the component. Before the beginning of manufacturing a new type of inductors, a lot of trial components have to produce, have to measure and have to try out. Finite element modeling is a well-tried process to examine engineering products before manufacturing them. To reduce the cost and the time of the design process, in the paper a finite element model has been built up to simulate inductors. In the paper the model is presented, which is able to simulate the important attributes of the component, for example the inductance, the impedance and the quality factor. The comparison of the experimental and the simulated attributes of the inductor will also be shown. By using the built up model the development possibilities of the inductor have been examined through the modification of the winding.
Pólik Z. Examination and development of RF inductors by using the finite element method,
, Széchenyi István University, Győr, 2008.
Pólik Z., '', in Diploma Thesis, (2008) -.
Pólik Z.Diploma Thesis2008)| false
Pólik Z., Kuczmann M. Examination and development of a radio frequency inductor,
, Vol. 12, 2008, pp. 230–233
Kuczmann M., 'Examination and development of a radio frequency inductor' (2008) 12Przeglad Elektrotechniczny: 230-233.
Kuczmann M.Examination and development of a radio frequency inductorPrzeglad Elektrotechniczny200812230233)| false
Bíró O., Richter K. R. CAD in electromagnetism,
in Series Advances in Electronics and Electron Physics
, Academic Press, New York, Vol. 82, 1991.
Richter K. R., '', in in Series Advances in Electronics and Electron Physics, (1991) -.
Richter K. R.in Series Advances in Electronics and Electron Physics1991)| false
Bíró O., Preis K., Richter K. R. On the use of the magnetic vector potential in the nodal and edge finite element analysis of 3D magnetostatic problems,
IEEE Trans. on Magn
, Vol. 32, 1996, pp. 651–654.
Richter K. R., 'On the use of the magnetic vector potential in the nodal and edge finite element analysis of 3D magnetostatic problems' (1996) 32IEEE Trans. on Magn: 651-654.
Richter K. R.On the use of the magnetic vector potential in the nodal and edge finite element analysis of 3D magnetostatic problemsIEEE Trans. on Magn199632651654)| false