In this study, we have investigated the fluctuations of radon levels in two experimental rooms constructed for secondary standard dosimetric calibration. The values over the short-term (the first two weeks) were in the range of 10–14 pCi/L of radon in air, while those of the long-term were between 6–14 pCi/L of radon. Even though the temperature and humidity was relatively constant during the second half of the rainy season, there was a trend towards lower radon values. It is concluded that ventilation is an important factor in indoor radon levels.
More than one hundred undisturbed soil samples from Northern Venezuela and the islands of Margarita and Los Roques have been analyzed for137Cs,40K,238U and232Th by -ray spectroscopy. The specimens were taken from between 5–10 cm below the earth's surface. Thus, they are valid not only for the137Cs deposition studies but also for the estimation of the natural -ray dose from primordial radionuclides that form the terrestrial component. The concentration of40K was directly determined from its 1461 keV -ray, while those of137Cs,238U and232Th were performed using a -ray from one of their daughter radionuclides: the 661 keV -ray of137mBa for137Cs, the 1760 keV -ray of214Bi for238U and the 2620 keV -ray of208Tl for232Th. Finally, the concentration values were compared with those of global estimates.
A rapid procedure for determining palladium in catalysts and geoiogical materials is presented. This method involves the use
of an241Am (100 mC) source for excitation and employs a PDP-11/05 processor for the data acquisition and analysis by energy-dispersive
X-ray fluorescence. The relative standard deviation for 5 independent determinations is less than 3% for 100 seconds of fluorescent
time. The calculated and measured values agreed well for both, the prepared standards and the doped Venezuelan laterites.
Finally, data on the different sources of error is given including counting time, sample preparation, and total error.
The determination of soil-gas anomalies especially 222Rn anomalies, are important to precisely locate fault traces, as well as to investigate earthquake precursors. In this paper, we have studied and compared new rapid methods for on site determinations of radon (222Rn), thoron (220Rn) and total radon (222Rn+220Rn) in soil-gas. These new techniques pump the soil-gas continuously from the soil through a simple sampling tube to the counting cell for one-minute with discarding the excess. Then, either four one-minute counting periods (5-minute technique) or nine one-minute counting intervals (10-minute technique) are followed immediately. In all the methods, conversely to Morse"s method, the first counting period (C1) was not employed for calculations. Three calculation methods for the five-minute technique, two for the ten-minute technique and a modified Morse"s method are compared with theoretical values and different real soil-gases with different radon/thoron ratios. The affect of different flow rates of soil-gases into the counting cell was also investigated. Finally, the ten-minute technique seems to be a little more accurate, but the 5-minute technique is much more suitable for seismic field studies when a much larger number of determinations are required in a short time.
A rapid, non-destructive method is presented for the determination molybdenum and cobalt in hydrodesulfurization catalysts
employing a PDP-11/05 computer-base radioisotope x-ray fluorescence technique. Precision for molybdenum and cobalt better
than 2.5% and 4.0%, respectively, are achieved in 100 sec of fluorescent time. The values obtained by this method are in agreement
with values from atomic absorption and neutron activation methods. Besides being nondestructive, only about 50 mg of sample
is needed, and no time-consuming acid dissolution is required as in atomic absorption and colorimetric methods. The results
for six different commercial catalysts are compared with determinations by atomic absorption, neutron activation analysis
methods as well as an x-ray fluorescence system with manual calculations of the percentage of molybdenum and cobalt.
The activity of137Cs was determined in mosses and their surrounding soils in three Venezuelan cloud forests. The concentration of137Cs in both the mosses and their respective soils were correlated with elevation (m.a.s.l.). This relationship was the result
of the cloud forest effect, no direct deposition by condensation below the base of the clouds and increasing deposition of137Cs with the density of the clouds. The ratio of the activity of137Cs in the mosses to their surrounding soils was in general the same for sites near the top of the mountains, but the ratio
at the Altos de pipe location was 3.5 times higher than that of the La Sierra mountain. This was explained by the difference
in the water content of the surface and the top soil layer. It was concluded that the137Cs measured in the mosses was from the soil effect rather than new deposition of137Cs in the last three years.
The determination of thirteen elements, eleven rare-earth elements (La, Ce, Nd, Sm, Eu, Gd, Tb, Ho, Tm, Tb and Lu), thorium and uranium were performed by instrumental neutron activation analysis for four geological reference materials (G-2, AGV-1, GSP-1 and SY-2) as well as our laboratory rare-earth standard. The analyses were performed using a low energy photon detector coupled to an Apple IIe microprocessor employed as a multichannel analyzer not only to collect the data but also for data analysis. Finally, based on this work we have proposed a simple, rapid routine method for the determination of eleven rare-earth elements, thorium and uranium in geological materials employing IVIC's RV-1 nuclear reactor.
More than fifty surface (2-10 cm) soil samples were collected in the Gran Sabana and Sierra de Pacarima, State of Bolivar
(Venezuela) and analyzed for their 137Cs activity. The measurements were performed by high resolution gamma-ray spectrometry employing a hyperpure germanium detector
with an energy resolution of about 1.8 keV for the 1.33 MeV line of 60Co and a counting efficiency greater than 25%. About 500 ml portions of dried soil samples with less than 85 mm particle size
were counted for 20,000 seconds and the data were collected, stored and analyzed with an IBM-compatible computer. The concentrations
of 137Cs in most samples were below the detection limit of 1.2 Bq/kg, but many of these soil samples could have been disturbed not
only by man but the nature itself, for example, by the large amount of rainfall in the wet season. Only 15% of the soil samples
were determined to have values equal or greater than 2 Bq/kg and only two of these were greater than 10 Bq/kg. The study area
was divided into five zones, which had different environmental characteristics: climate, annual average rainfall, temperature
ranges, elevations (m.a.s.l.), soil types and vegetation. Finally, it was concluded that the high 137Cs activities could be associated with the areas of higher annual rainfall and with very humid pre-mountainous climate rather
than with humid tropical climate.
Two sets of calibration standards for134Cs and137Cs were prepared by small serial dilution of a natural matrix standard reference material, IAEA-154 whey powder. The first set was intended to screen imported milk powders which were suspected to be contaminated with134Cs and137Cs. Therefore the concentration range of the calibration standards were about 40–400 Bq/kg. The precision of the preparation of the standard with about 7 Bq/kg of134Cs and 39 Bq/kg of137Cs at measurement time was 7.4% and 3.2%, respectively. The preparation of a similar standard by spiking the matrix with radioisotope solutions resulted in a poorer precision, about double that of the former technique. The other set of calibration standards was prepared to measure the environmental levels of137Cs in commercial Venezuelan milk powders. Their concentration ranged from 3–10 Bq/kg of137Cs. The accuracy of these calibration curves was checked by using IAEA-152 and A-14 milk powders. Their measured values were in good agreement with their certified values. Finally, it is shown that these preparation techniques by serial dilution of a standard reference material were simple, rapid, precise, accurate and cost-effective.