Search Results

You are looking at 1 - 10 of 14 items for :

  • Author or Editor: L.Q. Li x
  • Chemistry and Chemical Engineering x
  • Refine by Access: All Content x
Clear All Modify Search

Abstract  

Fingernails of pathologically diagnosed normal people, light esophageal epitheliosis patients, severe esophageal epitheliosis patients and esophageal cancer patients were irradiated and their elemental contents were determined by INAA. Multivariate statistical treatment of Ca, Cl, K. Mg, Se and Zn data shows that esophageal cancer patients are distinguishable from non-cancer patients. The accuracy computed by neural networks is greater than 80%.

Restricted access

Abstract  

The effect of itaconic acid (IA) content and heating rate on the stabilization reactions in poly(acrylonitrile-co-itaconic acid) (P(AN-co-IA)) was investigated by differential scanning calorimetry (DSC) with peak-resolving method. Increasing IA content was effective in decreasing the initial temperature and the heat evolved, and found to enhance oxidative reactions to some extent. While, promoting heating rate resulted in a shift of the exotherm to a higher temperature and a more rapid liberation of heat. The percentage of area of the first exothermic peak increased with increasing heating rate, which would be attributed to the enhancement of the free radical cyclization reactions.

Restricted access

Summary

A reversed-phase high-performance liquid chromatographic method was developed for the first time to simultaneously determine salicin and eight flavonoids in leaves of Salix matsudana, that is salicin, luteolin-7-O-glucoside, myricetin, apigenin-3′-oxyethyl-7-O-glucoside, rutin, quercetin, luteolin, kaempferol and apigenin. The separation of these compounds was achieved on a reversed phase C18 column (250 × 4.6 mm, 5 μm), with linear gradient of methanol in 0.2% phosphoric acid solution with a flow rate of 1.0 mL/min with UV detection at 246 nm. The calibration curves for the determination of all analytes showed good linearity over the investigated ranges (r > 0.999). The % relative standard deviation (% RSD) values were less than 0.34%, and the recoveries were between 95.79% and 99.94%. The values of luteolin-7-O-glucoside, salicin, myricetin, apigenin-3′-oxyethyl-7-O-glucoside, rutin, quercetin, luteolin, kaempferol, and apigenin were 1.0 μg g−1, 20.0 μg g−1, 32.9 μg g−1, 2.0 μg g−1, 29.5 μg g−1, 6.0 μg g−1, 1.0 μg g−1, 3.5 μg g−1, and apigenin was not found in the sample. This developed method can be used for evaluating the quality of different plant materials.

Full access

Abstract  

Poly(AN—co—St) (PAS) and poly(AN—St—MMA)(PASM) were synthetized by emulsion polymerisation. The glass transition temperatures (T g) of the copolymers and the relationship between T g and the components of the copolymers were investigated by differential scanning calorimetry. The results show that T g for the AN—St bipolymers has apeak value in the range 115–118°C at a content of 50 mass% St. When methyl methacrylate was added, the T g of the terpolymer was decreased by about 2–6°C.The thermostability and the activation energy E of degradation were determined by thermogravimetric analysis.

Restricted access

Summary  

Electronic stopping power of 19F in Ni, Pd and Gd was measured and compared to Mstar and SRIM calculation as well as experimental results published in literature. It turns out that the present electronic stopping power agrees reasonably well with them.

Restricted access

Abstract  

The molar heat capacities C p,m of 2,2-dimethyl-1,3-propanediol were measured in the temperature range from 78 to 410 K by means of a small sample automated adiabatic calorimeter. A solid-solid and a solid-liquid phase transitions were found at T-314.304 and 402.402 K, respectively, from the experimental C p-T curve. The molar enthalpies and entropies of these transitions were determined to be 14.78 kJ mol−1, 47.01 J K−1 mol for the solid-solid transition and 7.518 kJ mol−1, 18.68 J K−1 mol−1 for the solid-liquid transition, respectively. The dependence of heat capacity on the temperature was fitted to the following polynomial equations with least square method. In the temperature range of 80 to 310 K, C p,m/(J K−1 mol−1)=117.72+58.8022x+3.0964x 2+6.87363x 3−13.922x 4+9.8889x 5+16.195x 6; x=[(T/K)−195]/115. In the temperature range of 325 to 395 K, C p,m/(J K−1 mol−1)=290.74+22.767x−0.6247x 2−0.8716x 3−4.0159x 4−0.2878x 5+1.7244x 6; x=[(T/K)−360]/35. The thermodynamic functions H TH 298.15 and S TS 298.15, were derived from the heat capacity data in the temperature range of 80 to 410 K with an interval of 5 K. The thermostability of the compound was further tested by DSC and TG measurements. The results were in agreement with those obtained by adiabatic calorimetry.

Restricted access

Summary

The chemical compositions of essential oils extracted by n-hexane extract (HE), petroleum ether extract (PE), dichloromethane extract (DE), and hydrodistillation (HD) from Carthamus tinctorius L. (safflower) were analyzed by gas chromatography-mass spectrometry (GC-MS). A total of 86 compounds from four different extracts were identified, and the contents were 97.65%, 98.05%, 98.93%, and 99.68%, respectively. 6,10,14-Trimethyl-2-pentadecanone, hexadecanoic acid, methyl ester, hexadecanoic acid, 8,11-octadecadienoic acid, methyl ester, and 9,12,15-octadecatrien-1-ol were the major constituents of the extracts. The antidiabete activity was assayed in vitro by against protein tyrosine phosphatase 1B (PTP1B). The results showed that the HE exhibited the best in vitro inhibitory enzyme activity against PTP1B, which holds a good potential for treating diabetes and obesity.

Open access

Traditional Chinese medicine (TCM) has been widely used in many countries for thousands of years and played an indispensable role in the prevention and treatment of diseases, especially the complicated and chronic ones. However, the application of TCM in diseases is still not fully recognized by people around the world, the main reason is that Chinese herb is a very complex mixture containing hundreds of different components. Thus, it is essential to make quality control and evaluation of TCM. A new quality evaluation method, quantitative analysis of multi-components by single marker (QAMS), was developed to the quality control of alkaloids in TCM, a case study on Radix aconiti lateralis, named Fuzi in Chinese. Six alkaloids, including aconitine, hypaconitine, mesaconitine, benzoylaconine, benzoylmesaconine, and benzoylhypaconine, were selected as main components to evaluate the quality of Radix aconiti lateralis. The feasibility and accuracy of QAMS were checked by the external standard method, and various high-performance liquid chromatographic instruments and chromatographic conditions were investigated to verify its applicability. Using aconitine as the internal reference substance and the content of aconitine was calculated according to relative correction factors by high-performance liquid chromatography. The present results showed that there was no significant difference observed between the QAMS method and the external standard method with the relative average deviations less than 3.0%, and QAMS is an effective way to control the quality of herbal medicines and seems to be a convenient and accurate approach to analyze multi-composition when reference substances are unavailable.

Open access
Journal of Thermal Analysis and Calorimetry
Authors:
X.-C. Lv
,
Z.-C. Tan
,
Z.-A. Li
,
Y.-S. Li
,
J. Xing
,
Q. Shi
, and
L.-X. Sun

Abstract  

The (R)-BINOL-menthyl dicarbonates, one of the most important compounds in catalytic asymmetric synthesis, was synthesized by a convenient method. The molar heat capacities C p,m of the compound were measured over the temperature range from 80 to 378 K with a small sample automated adiabatic calorimeter. Thermodynamic functions [H TH 298.15] and [S TS 298.15] were derived in the above temperature range with a temperature interval of 5 K. The thermal stability of the substance was investigated by differential scanning calorimeter (DSC) and a thermogravimetric (TG) technique.

Restricted access