Search Results
capacity parameters with finite thickness and the transient point from infinite to finite space was studied in this work. 2 Experimental procedure The work was conducted at the vehicle engineering laboratory at Szent Istvan University (Godollo
(EDS). 2 Experimental procedure 2.1 Welding process The materials used in this experimental work were aluminum AA1100 and mild steel. They were cylindrical rods with 12 mm in diameter and 70 mm in length, as shown in Fig. 3 . Table 1 presents the
materials include P. conophora leaf , HCl and H 2 SO 4 acids. Ethanol, filter paper, air tight plastic containers were all used during the extraction of active ingredients from the P. conophora leaf to produce the inhibitor. 2.2 Experimental procedure
This paper presents a nonstandard experimental procedure for detection of the presence of salts in building materials. The proposed tests helped modeling the deterioration of specific historical building materials caused by salts. The specimens were subject to visual survey and scanning electron microscope analyses, after submerging them in salt solutions. The results showed the damage of brick, cement based mortar and lime based mortar, caused by various concentrations of sulphate and chloride solutions. By this method various types of salt crystals could be identified. In cement and lime based mortars larger extents of salt deposits were found. A relevant difference between the control samples and the salt treated samples was observed.
heat transfer coefficients are defined for air-flow in photovoltaic modules considering air speed, geographical location of the elements and air temperature. Important information about experimental procedures regarding heated cylinders is shown by [ 12
.; D) 0.04% Vol. 4 Experimental procedure The following steps are applied during the test of pool boiling heat transfer using deionized water and MgO nanoparticles based deionized water nanofluid: First, the pool boiling chamber and the heating element
varying amplitudes and frequencies were obtained. 3 Experimental test The experimental procedure consists of testing the MR damper (shown in Fig. 7 ) in INSTRON 8800 (shown in Fig. 8 ) under the same periodic excitation, which the mathematical model in
Experimental procedure Experimental work presented in this paper was a part of a master's thesis from the University of Pécs. The experimental investigation was achieved using beams and cubes made from conventional concrete and fiber
, Rp , (mm) 3–10 BHF, (kN) 3–9 Coefficient of friction, μ 0.01–0.15 Fig. 1. Geometrical setup, a) before forming, b) after forming 3 Experimental procedures Some samples of the U-bending test experiment were conducted in dry and lubrication conditions
castellated beams with octagonal openings and increase their stiffness by using a steel ring inside the edges of the openings as a stiffener. An experimental procedure is employed to study the behavior of this type of web opening stiffening. 2 Previous studies
