Search Results

You are looking at 1 - 10 of 44 items for

  • Author or Editor: T. T. Zhang x
  • All content x
Clear All Modify Search

The relationship between plant communities and elevation in the Guandi mountainous area was studied. Data from 89 sampling units, each of 10 m x 20 m size, taken along an elevation gradient were analyzed by TWINSPAN, DECORANA and diversity and evenness indices. The samples were clustered into 23 groups by TWINSPAN, representing 23 vegetation types. The composition and distribution of communities varied greatly along the altitude gradient, suggesting that community diversity is closely related to elevation in the Guandi Mountains. This is due to the change of temperature and water-conditions along the elevation gradient. Species heterogeneity and evenness were significantly correlated with elevation along the entire gradient, but showing first a trend of increases and then decreases, corresponding to the hypothesis of maximum diversity at medium elevation. Species richness varied greatly in the study area, and was not significantly correlated with elevation.

Restricted access

Abstract  

The miscibility of crystalline syndiotactic polystyrene (SPS)/non-crystalline atactic polystyrene (APS) blend was estimated by the crystallization dynamics method, which evaluated the nucleation rate, the crystal growth rate and the surface free energy parameter. The melting temperature depression suggested that SPS/APS blends were the miscible system but not in molecular level. The relationship between the blend content and the chemical potential difference evaluated at a constant crystal growth rate showed a good linear relationship. These facts suggested that SPS/APS blends contained the concentration fluctuation with the size between few nm to less than 80 nm.

Restricted access

Abstract  

The mixing state of poly(vinylidene fluoride) (PVDF) and two amorphous polymers,poly(methyl methacrylate) (PMMA) and poly(isopropyl methacrylate) (PiPMA) were investigated from the viewpoint of crystallization dynamics using simultaneous DSC-FTIR method. The crystallization rate (R *) and the growth rate of trans-gauche-trans-gauche’ (TGTG’) conformation (Rc *) depended on both the blend content (ϕ) and the crystallization temperature for PVDF/PMMA. The temperature and ϕ dependency of R * and Rc * were almost the same for PVDF/PMMA. However, R * and Rc * depended scarcely on f for PVDF/PiPMA, and the temperature dependency of R * differed from that of Rc * for PVDF/PiPMA. These results showed that PVDF and PMMA were miscible on molecular level, and that PVDF/PiPMA was immiscible and the concentration fluctuation existed in the PVDF-rich phase.

Restricted access

Thermal bridging caused by exposed concrete balcony slab is a major source of heat loss through energy efficient building envelopes. Moreover, thermal bridging can also create moisture management and indoor comfort challenges. Numerous investigations have been carried out to reduce heat transmittance through exterior building envelopes and minimize the energy use in buildings. The most effective way to minimize heat transmittance of exposed concrete balcony slabs is to thermally separate the exterior structure from the interior structure using thermal breaks. To enhance thermal separation, this paper investigates the effects of replacing high conductive materials such as reinforced concrete or structural steel with a multilayer composition of high-performance hybrid insulating systems. Reinforcing bars, such as fiber reinforced plastics (FRPs), having lower thermal conductivity than steel are used to connect interior to exterior and transfer loads. Numerical simulation tool THERM is used to study the effects of thermal breaks on energy performance of the concrete slab balcony joints. Simulation results indicate significant thermal performance improvement while high-performance hybrid insulating systems were used for exposed concrete balcony slab constructions, compared to traditional insulating systems used in similar constructions

Open access

Abstract  

The simultaneous DSC-FTIR was used for the observation of crystallization and melting of poly(vinylidene fluoride) (PVDF) and its blends with poly(methyl methacrylate) (PMMA) and poly(ethyl methacrylate) (PEMA). The isothermal crystallization was carried out under the condition of both α-form and γ-form crystallized competitively. The crystal growth rate of α -form and γ -form were evaluated from the absorbance changes at 795 cm-1 (α -form, CH2 rocking) and 810 cm-1 (γ -form, CH2 rocking) obtained by the DSC-FTIR. The crystal growth rate of γ -form decreased at the same crystallization temperature in the order of PVDF/syn-PMMA, PVDF/PEMA and PVDF/at-PMMA, which was corresponding to the order of interaction parameter. The mechanism of α -g transition of PVDF in the miscible blends with at-PMMA, syn-PMMA and PEMA was evaluated from the relationship between the decrease of α -form and the increase of γ -form. The critical crystallization temperature, at which the transformation from α -form to γ -form proceeded only in the solid state, shifted to higher temperature side in the order of interaction parameter.

Restricted access

Abstract  

The incorporation mechanism of Cs+ ions from CsNO3 into NH4Zr2(PO4)3 was studied on a mixture of CsNO3 and NH4Zr2(PO4)3 by powder X-ray diffraction analysis and by monitoring off-gases released from the mixture upon heating with a thermogravimetry analyzer connected to an infrared spectrometer. With increasing temperature, the decomposition of CsNO3 first started, followed by the conversion of NH4Zr2(PO4)3 to HZr2(PO4)3 with the release of NH3. At around 500°C, the Cs Zr2(PO4)3 phase started to appear as a result of the H+/Cs+ ion exchange. No Cs+ ion loss was observed at thermal treatment temperatures of 900°C and lower.

Restricted access

Summary

As a new form of traditional Chinese medicine (TCM), Zuojin pill extract is made containing Coptidis rhizoma (the rhizome of Coptis chinesis Franch. [Ranunculaceae]) and Euodiae fructus (the unripe fruit of Euodia rutaecarpa [Juss.] Benth. [Rutaceae]) at the ratio of 6:1 (w/w) and has been most widely used in TCM to treat gastro-intestinal disorders. However, the quality control is insufficient. For establishing an analysis method for the effective quality control of Zuojin pill extract, the active components of three protoberberine alkaloids (coptisine, palmatine, berberine, components from C. rhizoma) and two indolequinoline alkaloids (evodiamine, rutaecarpine, components from E. fructus) in Zuojin pill extract were determined simultaneously by high-performance liquid chromatography. Chromatographic separations were performed on an Inertsil ODS-3 column (4.6 mm × 250 mm, 5 μm). Elution was carried out at 25°C under isocratic conditions by using 25 mmol L−1 KH2PO4-25 mmol L−1 SDS-acetonitrile (1:1:2, v/v/v, adjusted pH to 3.0 using phosphoric acid) as a mobile phase with a flow rate of 0.5 mL min−1. Detection wavelength was set at 264 nm. Good linearity was obtained with correlation coefficient higher than 0.999 for all the analytes over the investigated concentration ranges. Three batches of Zuojin pill extract were successfully analyzed. The average percentages of coptisine, palmatine, berberine, evodiamine, and rutaecarpine in Zuojin pill extract were 5.35%, 3.92%, 16.64%, 0.03%, and 0.03%, respectively. Consequently, these protoberberine and indolequinoline alkaloids could be identified and determined easily by the established high-performance liquid chromatography (HPLC) method which can be used to evaluate and control the quality of Zuojin pill extract.

Restricted access

Abstract  

In order to identify the kinetic process of self-heating in DSC experiment for Ti+3Al→TiAl3 reaction, two approaches, linear-fitting approach developed from Semenov"s theory of spontaneous ignition and variation of Friedman method, were carried out with cylindrical Ti-75 at% Al samples. Following these approaches, two identical activation energies are obtained as 16915 kJ mol-1 and 1705 kJ mol-1, respectively. Compared with the activation energies of reactions and interdiffusions between Ti and Al, the possible rate-controlling process of self-heating in DSC experiment for Ti+3Al→TiAl3 reaction is the interdiffusion between Ti and Al through TiAl3-layer.

Restricted access

Summary  

Adsorption microcalorimetry has been employed to study the interaction of ethylene with the reduced and oxidized Pt-Ag/SiO2catalysts with different Ag contents to elucidate the modified effect of Ag towards the hydrocarbon processing on platinum catalysts. In addition, microcalorimetric adsorption of H2, O2, CO and FTIR of CO adsorption were conducted to investigate the influence of Ag on the surface structure of Pt catalyst. It is found from the microcalorimetric results of H2and O2adsorption that the addition of Ag to Pt/SiO2leads to the enrichment of Ag on the catalyst surface which decreases the size of Pt surface ensembles of Pt-Ag/SiO2catalysts. The microcalorimetry and FTIR of CO adsorption indicates that there still exist sites for linear and bridged CO adsorption on the surface of platinum catalysts simultaneously although Ag was incorporated into Pt/SiO2. The ethylene microcalorimetric results show that the decrease of ensemble size of Pt surface sites suppresses the formation of dissociative species (ethylidyne) upon the chemisorption of C2H4on Pt-Ag/SiO2. The differential heat vs. uptake plots for C2H4adsorption on the oxygen-preadsorbed Pt/SiO2and Pt-Ag/SiO2catalysts suggest that the incorporation of Ag to Pt/SiO2could decrease the ability for the oxidation of C2H4.

Restricted access