As a new form of traditional Chinese medicine (TCM), Zuojin pill extract is made containing Coptidis rhizoma (the rhizome of Coptis chinesis Franch. [Ranunculaceae]) and Euodiae fructus (the unripe fruit of Euodia rutaecarpa [Juss.] Benth. [Rutaceae]) at the ratio of 6:1 (w/w) and has been most widely used in TCM to treat gastro-intestinal disorders. However, the quality control is insufficient. For establishing an analysis method for the effective quality control of Zuojin pill extract, the active components of three protoberberine alkaloids (coptisine, palmatine, berberine, components from C. rhizoma) and two indolequinoline alkaloids (evodiamine, rutaecarpine, components from E. fructus) in Zuojin pill extract were determined simultaneously by high-performance liquid chromatography. Chromatographic separations were performed on an Inertsil ODS-3 column (4.6 mm × 250 mm, 5 μm). Elution was carried out at 25°C under isocratic conditions by using 25 mmol L−1 KH2PO4-25 mmol L−1 SDS-acetonitrile (1:1:2, v/v/v, adjusted pH to 3.0 using phosphoric acid) as a mobile phase with a flow rate of 0.5 mL min−1. Detection wavelength was set at 264 nm. Good linearity was obtained with correlation coefficient higher than 0.999 for all the analytes over the investigated concentration ranges. Three batches of Zuojin pill extract were successfully analyzed. The average percentages of coptisine, palmatine, berberine, evodiamine, and rutaecarpine in Zuojin pill extract were 5.35%, 3.92%, 16.64%, 0.03%, and 0.03%, respectively. Consequently, these protoberberine and indolequinoline alkaloids could be identified and determined easily by the established high-performance liquid chromatography (HPLC) method which can be used to evaluate and control the quality of Zuojin pill extract.
Authors:L. Liu, T. Zhao, X. M. Cheng, C. H. Wang, and Z. T. Wang
Harmaline and harmine accounted for more than 70% in composition in extracts of P. harmala. More attention, however, should be paid to the other alkaloids which would be favorable or unfavorable to the efficacy and safety of the products. It was necessary to determine these trace alkaloids in the extracts; thereafter, most of them have been characterized. Diglycoside vasicine, vasicine, vasicinone, harmalol, harmol, tetrahydroharmine, 8-hydroxy-harmine, ruine, harmaline, and harmine were separated and identified with reference substances and characteristic MS spectra in extracts by liquid chromatography-electrospray ionization-mass spectrometry (LC-ESI-MS) and high-performance liquid chromatography (HPLC). Three trace alkaloids, vasicine, harmalol, and harmol were determined using the developed chromatographic separation method subsequently. The average contents of vasicine, harmalol, and harmol in extracts of ten batches were 2.53 ± 0.73, 0.54 ± 0.19, and 0.077 ± 0.03%, respectively. The total content of the three alkaloids was 3.23 ± 0.90% (from 1.81 to 4.48%). For rough estimation of all the relative alkaloids except of harmaline and harmine, the average total areas of all peaks in extracts varied from 4.35 to 26.64% detected at 220, 254, 265, 280, and 380 nm, respectively. The results indicated that area normalization method was powerless for the quality evaluation for traditional herb medicine consisting of numerous compounds with highly differential features. It might be concluded that LC-MS or HPLC could be utilized as a qualitative and quantitative analytical method for quality control of the extracts from seeds of P. harmala L.
Effects of nano-metal powders (aluminum and nickel) addition on the thermooxidative degradation of binder PEG in air atmosphere
from 20 to 350°C were studied by TG/DTA and in-situ FTIR. TG/DTA results showed that the addition of nano-Al slowed down the
degradation process of PEG in the early period but accelerated the process in the late period; the addition of nano-Ni made
the PEG degradation process begin as soon as melted. The in-situ FTIR results showed that nano-Ni promoted the thermooxidative
degradation of PEG in air, and made the degradation process of PEG complete much earlier.
Authors:B. Feng, Z.B. Xu, X. Wang, F. Jiang, G.J. Zhao, C. Xiang, and T. Wang
High molecular weight (HMW) glutenin subunits are important seed storage proteins in wheat and its related species. Novel HMWglutenin subunits in Aegilops tauschii accession of TA2484 were detected and characterized. SDS-PAGE analysis revealed the y-type subunit from TA2484 displayed similar electrophoretic mobility compared to that of 1Dy12 subunit. However, the electrophoretic mobility of x-type subunit was faster than that of 1Dx2 subunit. The primary structure of the two cloned subunits from TA2484 was similar to that of the x- and y-type subunits reported before. However, the 148 residues of the x-type subunit, which contained the sequence element GHCPTSLQQ, in the middle of the repetitive domain was quite different from other x-type subunits. Moreover, the 68 residues in this region were identical to those of the y-type subunits from the same accession. Consequently, 1Dx2.3*t (x-type subunit of TA2484) contains an extra cystenin residue located at the repetitive domain, which is novel compared to the x-type subunits reported so far. Phylogenetic analysis indicated that two subunits from accession TA2484 were in the x- and y-type subunit cluster, but bootstrapping value of 100% gave high support for the spilt between two subunits (1Dx2.3*t and 1Dy12.3*t) and their alleles, respectively. A hypothesis on the genetic mechanism generating this novel sequence of 1Dx2.3*t subunit is suggested.
Authors:S. Wang, Z. Tan, Y. Di, F. Xu, M. Wang, L. Sun, and T. Zhang
As one primary component of Vitamin B3, nicotinic acid [pyridine 3-carboxylic acid] was synthesized, and calorimetric study and thermal analysis for this compound
were performed. The low-temperature heat capacity of nicotinic acid was measured with a precise automated adiabatic calorimeter
over the temperature rang from 79 to 368 K. No thermal anomaly or phase transition was observed in this temperature range.
A solid-to-solid transition at Ttrs=451.4 K, a solid-to-liquid transition at Tfus=509.1 K and a thermal decomposition at Td=538.8 K were found through the DSC and TG-DTG techniques. The molar enthalpies of these transitions were determined to be
ΔtrsHm=0.81 kJ mol-1, ΔfusHm=27.57 kJ mol-1 and ΔdHm=62.38 kJ mol-1, respectively, by the integrals of the peak areas of the DSC curves.
Authors:C. Li, C. Wang, X. Liu, Z. Zheng, L. Wang, Q. Zhu, M. Kang, T. Chen, and C. Liu
In terms of pre-safety assessment of a potential site for high-level radioactive wastes disposal in China, the geochemical
behavior of key radionuclides which tend to be released from the repository must be thoroughly investigated. 99Tc is a long-lived fission product with appreciable productivity in nuclear fuel, and Tc (+7) has unlimited solubility in
near-field geochemical environments. In this study, the effects of ionic strength and humic acid on 99TcO4− sorption and diffusion in Beishan granite were investigated with through-diffusion and batch sorption experiments. Results
indicated that the effective diffusion coefficients (De) of 99TcO4− in Beishan granite varied from 1.07 × 10−12 to 1.28 × 10−12 m2/s without change with ionic strength, while the distribution coefficients (Kd) negatively correlated with ionic strength of the rock/water system. This study also indicates that there is no evident influence
of humic acid concentration on the diffusion behavior of 99TcO4− in Beishan granite, due to the limited interaction between humic acid and 99TcO4−.
Authors:J. Li, W. Dai, G. Xiao, H. Wang, Z. Zhang, and T. Wu
99Tc is an important radionuclides related to repository safety assessment. The mobility pertechnetate (TcO4−) can be reduced to immobility technetium(IV) hydrous oxides (TcO2·nH2O) by Fe(II)-bearing minerals. In China, Gaomiaozi (GMZ) bentonite is regarded as the favorable candidate backfilling material
for the HLW repository, which is contained some FeO. The diffusion behavior of 99Tc was investigated in GMZ bentonite by through- and out-diffusion methods. The effective diffusion coefficient (De), the accessible porosity (εacc), apparent diffusion coefficient (Da) and distribution coefficient (Kd) were decreased with the increasing of dry density. The De values were (2.8 ± 0.2) × 10−11 m2/s and (3.5 ± 0.2) × 10−12 m2/s at dry density of 1,600 and 1,800 kg/m3, respectively. It was indicated that the dominating species was TcO4− during the diffusion processing. While, out-diffusion results showed that part of TcO4− may be reduced by Fe(II). The relationship of De and εacc could be described by Archie’s law with exponent n = 2.4 for 99Tc diffusion in GMZ bentonite. Furthermore, the relationship between Da and dry density (ρ) was exponential.
The present study was performed to investigate the effect of β-aminobutyric acid (BABA) treatment on defence activation in grape berries and to analyse its cellular mechanism. The results implied that BABA treatment at an effective concentration of 20 mM significantly inhibited gray mould rot caused by Botrytis cinerea in grape berries by inducing resistance. Accordingly, 20 mM BABA triggered a priming defence in grape suspension cells, since only the BABA-treated cells exhibited an accelerated ability for augmenting defence responses upon the pathogen inoculation. The primed cellular reactions were related to an early H2O2 burst, prompt accumulation of stilbene phytoalexins and activation of PR genes. Thus, we assume that 20 mM BABA can induce resistance to B. cinerea infection in intact grape berries perhaps via intercellular priming defence. Moreover, the BABA-induced priming defence is verified, because no negative effects on cell growth, anthocyanin synthesis, and quality impairment in either grape cells or intact berries were observed under low pathogenic pressure.
Authors:M.-H. Wang, Z.-C. Tan, Q. Shi, L.-X. Sun, and T. Zhang
heat capacities of 2-benzoylpyridine were measured with an automated adiabatic
calorimeter over the temperature range from 80 to 340 K. The melting point,
molar enthalpy, ΔfusHm,
and entropy, ΔfusSm,
of fusion of this compound were determined to be 316.49±0.04 K, 20.91±0.03
kJ mol–1 and 66.07±0.05 J mol–1
K–1, respectively. The purity of the compound
was calculated to be 99.60 mol% by using the fractional melting technique.
The thermodynamic functions (HT–H298.15) and (ST–S298.15) were calculated based
on the heat capacity measurements in the temperature range of 80–340
K with an interval of 5 K. The thermal properties of the compound were further
investigated by differential scanning calorimetry (DSC). From the DSC curve,
the temperature corresponding to the maximum evaporation rate, the molar enthalpy
and entropy of evaporation were determined to be 556.3±0.1 K, 51.3±0.2
kJ mol–1 and 92.2±0.4 J K–1
mol–1, respectively, under the experimental
Authors:X.M. Fang, H.Z. She, C. Wang, X.B. Liu, Y.S. Li, J. Nie, R.W. Ruan, T. Wang, and Z.L. Yi
Waxy wheat (Triticum aestivum L.) is grown throughout the world for its specific quality. Fertilization and planting density are two crucial factors that affect waxy wheat yield and photosynthetic capacity. The objectives of the research were to determine the effects of fertilization and planting density on photosynthetic characteristics, yield, and yield components of waxy wheat, including Yield, SSR, TGW, GNPP, GWPP, PH, HI, Pn, Gs, Ci, E and WUE using the method of field experiment, in which there were three levels (150, 300, and 450 kg ha−1) of fertilizer application rate and three levels (1.35, 1.8, and 2.25 × 106 plants ha−1) of planting density. The results suggested that photosynthetic characteristics, yield, and yield components had close relationship with fertilization levels and planting density. Under the same plant density, with the increase of fertilization, Yield, SSR, TGW, GNPP, GWPP, HI, Pn, Gs, E and WUE increased and then decreased, PH increased, but Ci decreased. Under the same fertilization, with the increase of plant density, Yield, SSR, TGW, GNPP, GWPP, HI increased and then decreased, PH, Pn, Gs and E increased, PH and WUE declined. The results also showed that F2 (300 kg ha−1) and D2 (1.8 × 106 plants ha−1) was a better match in this experiment, which could obtain a higher grain yield 4961.61 kg ha−1. Consequently, this combination of fertilizer application rate and plant densities are useful to get high yield of waxy wheat.