Search Results
Abstract
PEI/PEEK blends have been prepared and analysed by DSC. The blends are compatible over the full composition range in that amorphous samples are transparent and exhibit a single Tg varying with composition between the limits of the two components. The crystallisation kinetics of PEEK from the blend melt has been measured by DSC but the technique is limited to blend compositions above 20% PEEK. The use of a polarised light microscope to measure crystallization kinetics and melting behaviour of blends with compositions as low as 2 and 5% PEEK is discussed. In general, since the extent rather than the rate of crystallization is measured directly, the polarised light microscopy extends the measurement to slower rates and so to a wider temperature range.
Abstract
Blends of poly(ether ketone) (PEK) with poly(terephthaloyl-imide) (a thermoplasticpolyimide, TPI) were studied by temperature-modulated DSC (TMDSC) and X-ray diffraction. Samples were prepared by compression moulding of the premixed materials at 400°C and quenched to prevent crystallisation.The amorphous blends showed a single glass transition but with a jump in the temperature value at 60 mass% of PEK, indicating limited miscibility of the system at both sides of the composition series in the quenched, glassy state. Two cold crystallisation peaks over the concentration range 30 to 70 mass% of PEK were observed, but only one for all other compositions. A single melting peak was observed in all systems.Blends crystallised from the glassy state showed eutectic behaviour with the presence of the crystals of both pure components. This is the first reported case of two semicrystalline polymers exhibiting eutectic co-crystallisation. The formation of eutectic crystals is proof of full miscibility of the two polymers in their liquid state, i.e. at a temperature of 400°C and above. Blends cooled from the melt at a cooling rate of 2 K min–1 showed a single glass transition and an extended melting range.Crystallisation during a second melting run generally starts at a different temperature then during the first run indicating chemical changes occurred in the molten state. This change was also verified by an exothermic peak above the melting temperature using TMDSC.
Abstract
This biomaterials overview for selecting polymers for medical devices focuses on polymer materials, properties and performance. An improved understanding of thermoplastics and thermoset properties is accomplished by thermal analysis for device applications. The medical applications and requirements as well as the oxidative and mechanical stability of currently used polymers in devices are discussed. The tools used to aid the ranking of the thermoplastics and thermosets are differential scanning calorimetry (DSC), thermogravimetry (TG), thermal mechanical analysis (TMA) and dynamic mechanical analysis (DMA) as well as a number of key ASTM polymer tests. This paper will spotlight the thermal and mechanical characterization of the bio-compatible polymers e.g., olefins, nylon, polyacetals, polyvinyl chloride and polyesters.
1983 Environmental resistance of carbon fibre-reinforced polyether ether ketone Composites 14 3 251 – 253 . [6
exhibit near-brittle fracture behavior, such as Polyether-ether-ketone (PEEK) or epoxy-based composites used in aerospace structures. The connection between the two theories can be established by setting the area under the tensile-separation curve equal to
materials include polyphenylsulfone (PPSU), polyether ether ketone (PEEK), and polyaryletherketone (PAEK), while polyethylene terephthalate glycol (PETG) and polylactic acid (PLA) emerge as common choices [ 15 ]. Characterized by thermal resilience and